Communications Setup

<< Click to Display Table of Contents >>

Navigation:  Instruments > SuperM.O.L.E.® Gold > Setup >

Communications Setup

Prior to operation the M.O.L.E. Profiler must be configured to properly communicate with the M.O.L.E.® MAP Software.

Important Information

The M.O.L.E.® MAP software must be installed prior to communications setup. (Refer to Software Installation for more information).

To connect the M.O.L.E. Profiler:

1)Locate the computer Interface cable and plug the 9-pin connector into a computer COM Port and the other end into the M.O.L.E. Profiler Data Port.

Important Information

If no Serial Port exists, use the included USB adaptor to connect the interface cable to the computer.

M.O.L.E. Profiler Connection

2)After the computer interface cable is connected to a computer, the Communication (COM) Port must be configured in the software to match the same COM Port as the computer so they can communicate.
3)Start the software program by either double-clicking the M.O.L.E.® MAP software icon or selecting it from the ECD program sub-menu.

Start Program

4)On the M.O.L.E. menu, click the Select Instrument command.
5)Select the desired instrument from the dialog box. If there are none displayed, click the Scan for Instruments command button to detect all available instruments.

supermolegold-0000

Important Information

If the software does not detect a M.O.L.E. Profiler, using the communication cable connect it to the computer and click the Scan for Instruments command button to search again. M.O.L.E.® MAP software allows multiple instruments to be connected to a computer at one time. Selecting the Scan for Instruments command button will detect all instruments and display them in the dialog box. If no instrument is detected the software displays all of the Demonstration thermal profilers to select from.

6)Click the OK command button to accept or Cancel to quit the command.