Align Profile To Dimensions

<< Click to Display Table of Contents >>

Navigation:  Software > Menu and Tool Commands > Profile Menu >

Align Profile To Dimensions

If sensors are placed so they enter and exit machine zones at different times, the resulting Data Plots lag behind one another. The Align Profile To Dimensions command automatically aligns the (X) values specified in the Set Assembly Information command for each Data Plot so they are aligned in time so they can be easily compared during analysis.

Important Information

This is available in both Engineer & Verify Modes.

 

To align profile to dimensions:

Important Information

A conveyor speed and sensor locations must be set to properly use this command. Refer to topic Set Machine Information and/or Conveyor Speed Indicator for more details.

1)On the Profile menu, click Align Profile To Dimensions the channel lag values are automatically calculated, and the Data Plots adjust to reflect them. A check mark appears to the left of the command indicating the software is in Align Profile To Dimensions mode. Repeat this step to disable the command.

mole_map-3190

Important Information

When downloading a data run from the M.O.L.E. Profiler, the default sensor alignment can be specified in the Profile tab of the Preferences dialog box. Refer to topic Profile for more information.