ECD MEGAM.O.L.E.® MAP Users Help Guide

Navigation: Equipment > MEGAM.O.L.E.® > Main Module

The Main module is the controller unit of the MEGAM.O.L.E. Profiler. This module stores the recorded data runs that can be downloaded to a computer through the Data Port located on the Power Pack battery.

Symbol_(Info)

To configure and download data from the Main Module, the Power Pack battery must be connected to the unit. Refer to topic Power Pack Battery for more information.

MegaMOLE_Main

Features/functions:

•	Buttons: ON/OFF, Record & OK.

Button:	Action:
ON/OFF	Turns Main module "ON/OFF".
Record	Starts/Stops Main module recording data.
OK	Invokes "OK" process where the last recorded profile is compared to pre-configured criteria resulting in a "Pass" or "Fail" mode.

•	Activity indicators: These are LED's that indicate what state the M.O.L.E. Profiler is in. Refer to the illustration and table below.

LED:	Action:	LED Color
ON/OFF	Indicates Main module is "ON" and idle	Green (Flashing)
Record	Indicates Main module is recording data	Green (Flashing)
OK	Indicates recorded profile passes pre-configured criteria using the Target 10-OK tab in the software.	Green - Pass (Solid) Red - Fail (Solid)
Temp(erature)	Indicates if the internal temperature is at or above a certain threshold.	Red (Slow Flash) >40°C Red (Solid) >85°C
Battery	Indicates when the Power Pack battery voltage is low	Red (Slow Flash) <3.0V
RF (Radio Frequency)	Indicates when main module and receiver is transferring data	Blue

•

Interface Connectors: There are two interface connectors in the Main module. The front connector interfaces with the I/O Pod and is where the converted digital data from the I/O pod is transferred to the Main module. The rear connector interfaces with the Power Pack battery and power and signal data is transferred.

•	Alignment Sockets: These are where the mating I/O Pod and Power Pack battery alignment pins are inserted.

•	RF Antenna Connector: This is where the Optional RF antenna is connected.