|
Navigation: Basics > Setup > Charging the Power Pack Battery
|
Because the M.O.L.E. profiler is powered by a rechargeable Power Pack battery, it is important that it is charged and operating properly prior to performing every experiment. A spare Power Pack battery may be ordered so the one battery is charging while the other one is being used.
| 1) | Slide the interchangeable plug into the adaptor until it clicks indicating that is fully seated. |
| 2) | Plug the transformer end of the charger into a wall outlet and the USB connector end into the Power Pack. |
.gif)
|
A completely discharged Power Pack takes about 8 hours to be fully charged. For quick charges, the Power Pack battery can be charged for 15 minutes allowing one 10 minute data run to be performed.
|
| 3) | When the charging cycle is complete, connect the Power Pack to the M.O.L.E.. |
|
The Power Pack battery can be charged continuously whenever the M.O.L.E. profiler is not being used, however, if the M.O.L.E. profiler is going to sit idle for five days or more, you may want to remove it from the charger.
|
|
