Product Selection Box:
Where predefined products are listed for selection
Status Indicator:
Indicates when the OvenWATCH is recording product data and the alarm status.
Green = OK
Red = Alarm
Start/Stop
Watch:
Starts and stops the OvenWATCH recording process
Product
Counter:
Displays the elapsed time since start and the count of product that has entered
and exited the oven
Product
Tracker:
A graphic representation of the product position in the oven
Product
Identifier:
Identification photo of the selected product
Product
Controls:
The command center for defining and reviewing product data
Baseline
Profile Map:
A thumbnail view of the profile assigned to the selected product
Gray
Area:
This is one of those gray areas that are undefined
M.O.L.E.
Indicator:
Indicates when the MOLE is inserted into the station
Liquidous:
This line shows the liquidous temperature for the
selected paste
Soak
Temperatures:
The blue and green lines show the beginning and end soak temperatures
Conveyor
Speed Status:
Indicates the speed of Baseline Setpoint, Actual, and Dynamic Profile
Zone
Temperature Compliance:
Compares the "Baseline" zone temperatures and setpoints (thinner,
gray line) with the "Actual" zone temperatures and setpoints (thicker,
colored line). The small box is the "Baseline" probe temperature
Zone
Temperature Compliance:
Compares the "Baseline" zone temperatures and setpoints (thinner,
gray line below the colored box) with the "Actual" zone temperatures
and setpoints (thicker, colored line at bottom). The small red box is the "Baseline"
probe temperature. The top of the large colored box is the oven setpoint In
this example - the oven is set to a higher temperature from the setting that
was used for the "Baseline" profile
Profiles:
Dashed Data Plots represent a predicted or "Dynamic" profile based
on the current probe temperatures and the "Baseline" Profile. Solid
Data Plots represent a previously recorded "Baseline" profile
Zones:
Zones as defined by the oven and the profile measure that is occurring in this
zone
Conveyor
Dimensions:
Distance measurement inside the oven shown in the units selected
Channel
Check Boxes:
Displays the associated Data Plot on the Data Graph
Sensor
Locations:
Displays the sensor locations that were entered from the baseline profile
Profile
Data;
Displays profile information depending on the Data Tab selected. Currently -
Profile Measures is being shown
Data
Tabs:
When the Profile worksheet is active, you can access a variety of sensor information
using these tabs
Worksheet
Tabs:
The standard worksheets are accessed using these tabs
X/Y
Readout:
Continuously displays the X and Y-axes values for the mouse pointer location
Date
and Time:
The current time and date of the PC
Click here to close window