|
If sensors are placed along a line parallel to the direction of flow in a conveyorized process so they enter and exit oven zones at different times, the resulting Data Plots lag behind one another. Auto Lag automatically aligns the X-axis maximum peak values for each Data Plot so the results can be easily compared during analysis.
.gif)
|
A Conveyor speed must be set to properly use Auto Lag. Refer to section Zone Matrix and/or Oven Configure for more information.
|
Channel Lag Indicator
| 1) | Select the Auto Lag command button. The channel lag values will automatically be calculated, and the Data Plots adjust to reflect them. When Channel lag is enabled, a check mark appears in the Show Lag check box and a small triangle appears on the lower end of the process origin line. |
|
If Channel Lag values were previously entered in the Channel Lag dialog box, Auto Lag will automatically overwrite the current values. Refer to section Sensors for more information.
|
| 1) | Click the Show Lag check box to remove the check mark and return the Data Plot(s) to the original positions. |
.gif)
|
Auto Lag only used displayed channel Data Plots. Auto Lag values will not be calculated for channels that are not displayed.
|
|
