Cleaning Instructions

<< Click to Display Table of Contents >>

Navigation:  Sensor Platforms > WaveRIDER® NL 2 > Service and Troubleshooting >

Cleaning Instructions

After completing the data collection process, cleaning the RIDER is very important because some types of flux tend to build up on the RIDER very quickly. The following information will discuss various cleaning machines and methods used to clean the RIDER, and how to get it ready for the data run.

Caution

The M.O.L.E. Profiler must be removed before the RIDER is cleaned because it may be damaged or destroyed by water or solvents.

1)Turn the locking latch and the raise barrier box cover until it comes to a rest. Remove the configuration plug, and pull the extractor handle to remove the M.O.L.E. Profiler.

waverider-smg

2)Using a brass wire brush with fine bristles, clean the contact sensors on the bottom of the RIDER pallet. When cleaning the sensors, use enough force to get them cleaned and free from debris but not too much that they will be damaged.
3)Once the M.O.L.E. is removed, make sure that the configuration plug is tucked under the cover while it is closed and rotate the locking latch to secure.
4)Open the barrier box cover allowing inside completely dry. Once the RIDER is dry and insert the M.O.L.E. into the RIDER.